Cleats and Accessories

Ensures correct alignment of control lines into the cleat.       Applications: Suits medium C-Cleat and...

Used to keep the uncleated line within close proximity to the cleat, facilitating recleating.     Applications: Suits large C-Cleat and T-Cleat ...

Can be used to correct alignment. Can be stacked in opposite directions to create a parallel riser. Backing plate distributes loads evenly under t...

Front mounted fairlead, suits small C-Cleat and T-Cleat. Allows precise cleating and release from any lead angle. Lower entry efforts for off-cent...

Lightweight Flairleads are top-mounted sculpted eyestraps.They feature stainless wearguards and are available in black, red, green, yellow or blue....

The 150 Cam-Matic, the original ball bearing cam cleat, is still the most popular in the world. Its tough Hardkote-anodised pawls and base are spec...

Wire fairleads maintain a low profile while holding the line close to the cleat. Use the HK298 wire fairlead with the HK150 and HK365 cleats to pla...

Eyestraps provide a fairlead on cams and hold the line at the cleat.Features: Height above cam: 12mm Length: 36mm Width: 11mm Weight: 4.5g Fastener...

Riser/Curved surface adaptor, suits medium C-Cleats and T-Cleats Weight: 30g

Can be used to correct alignment. Can be stacked in opposite directions to create a parallel riser. Backing plate distributes loads evenly under t...

A wedge kit is available for each cam. Cleats can be angled up to 15 degrees.The 150, 338, 365 and 423 cleats also fit flat or 15 degree risers. Ea...

Harken's 280 Offshore Cam-Matic is designed to complement the Midrange block series.It will accommodate line to 5/8" (16mm) and serves well in high...

Use cam swivel bases when leads must rotate to face the trimmer. Ball bearing swivel bases feature dual rows of Delrin ball bearings. Specification...

Intensive development efforts have produced this range of cleats that provide unbeatable holding power, yet are designed for easy cleating and rele...

The 150 Cam-Matic, the original ball bearing cam cleat, is still the most popular in the world.Its tough Hardkote-anodised pawls and base are speci...

Intensive development efforts have produced this range of cleats that provide unbeatable holding power, yet are designed for easy cleating and rele...

Top Guide to suit Selden CC27 Cam Cleat (433-101-01R)   Rope capacity:  3 - 7 mm Hole spacing:  27 mm Weight:  3 g

Carbo-Cams are breakthrough plastic cleats designed for use on high-performance boats where weight and performance are critical. Carbon matrix pawl...

Seld ©n cam cleats c-c 27 and 38 mm are made of carbon fibre reinforced polyetherimide. This material is selected for its high resistance to fricti...

Carbo-Cams are breakthrough plastic cleats designed for use on high-performance boats where weight and performance are critical.Carbon matrix pawls...

A wedge kit is available for each cam. Cleats can be angled up to 15 degrees. The 150, 338, 365 and 423 cleats also fit flat or 15 degree risers. E...

A wedge kit is available for each cam. Cleats can be angled up to 15 degrees.The 150, 338, 365 and 423 cleats also fit flat or 15 degree risers. Ea...

Rope Fairlead to suit CC27 Clam Cleat (433-101-01R) Rope capacity:  3 - 7 mmHole spacing:  27 mmWeight:  14 g